Originally Posted by
gssixgun
I am thinking a 2 stage attack
Step 1.
Some spine off the hone Circles at the 4k level probably start at about a 45° angle to eliminate the frown, then drop to maybe 1 spine width above the hone.. Both sides that should even up the edge and not dull it out totally... Go Slow and Test often on a flat surface..
If that works
Step 2.
I think I would try some creative (you will need to trim the tape to make this work) taping, since you can't add steel back I would not take more away trying to fix it.. Maybe start with two layers on the stamped side and 3 on the hump and see what that does using the Magic Marker test with a few laps... You might have to adjust up or down.. Watch the wear on the Tape too make sure you are shifting pressure correctly...
This may or may not work but at least you are not making it worse by practicing on it :)
If it works then you can decide it it is even possible to grind off enough steel to correct the bad wear and get the right geometry back without the tape :shrug: