Results 1 to 7 of 7
11Likes
Thread: Dealing with a Microchip
Threaded View
-
06-04-2017, 04:50 PM #1
- Join Date
- Apr 2017
- Location
- Armonk, NY
- Posts
- 551
Thanked: 39Dealing with a Microchip
Hey everyone, I have a quick question about removing a microchip from an edge. Before using a razor yesterday, vintage with a very sharp factory edge, I noticed a microchip close to the toe. This was under 60x magnification. The shave wasn't bad, but a bit harsh. I'm not sure if it was the microchip or the factory honing.
To remove this would I need to send it all the way to the 1K and go from there or is it possible to remove it on a finisher? (I.e. Escher, JNat). I could also put it on a coticule if necessary.
Ideally I would like to run it a couple of laps on a finisher and be done but I'm guessing it will be a bit trickier than that.
Any help or input would be appreciated. Thanks!