I bought a carborundum 124 Hone (NOS) marked "FINE" to be my bevel setter. The first razor to touch it is a Torrey restoration project that i got a little careless with the dremel and ended up sanding someofthe edge off (.5mm max). I bread knifed it flat on the hone and then began to set the bevel. I know i've got a lot of metal to get through but it's taking longer thani think it should. I used the same technique to get a bad chip out of my wapi and the beveling went quick with some 2k wet/dry sandpaper... anyway to the question

Are carborundums slow cutters or are Torrey's just hard steel? thank you!