Hi everyone. I'm somewhat new to this. I've seen the term "pyramid" used to describe a honing technique. Could someone please explain what this means? I have two old razors and a Norton 4000/8000 but haven't been succesful yet. Thanks
Printable View
Hi everyone. I'm somewhat new to this. I've seen the term "pyramid" used to describe a honing technique. Could someone please explain what this means? I have two old razors and a Norton 4000/8000 but haven't been succesful yet. Thanks
The pyramid method is a honing method where you switch back and forth from the 4x side to the 8k side of the norton.
on the 4000 followed by the 800o the number of laps back and forth on the hone goes like this;
1/5
3/5
3/5
5/5
10/5
15/5
10/5
5/5
3/5
3/5
1/5
1/5
1/5
You don't have to go as high as 15 on the 4k if it's almost ready to shave and ending with a few 1/3 swipes seems to work for most guys.
It's all in the Help Files and described well in other posts. Do a search for more info.
X
If you perform the above pyramid then be sure and perform the thumb test and/or the hanging hair test frequently to judge the rate of change. You can stop at any point and finish with a 1/3, 1/3, 1/5 and then do a test shave.
Let us know how it goes.
I found a pyramid scheme that is a bit different and seems to be working for me. It seems to concentrate on more strokes on the higher grit stone than the lower. I use it on the Norton 4X8K, a Sharpton 15K and a .05 micron Hand American.
Norton 4X8
4/16
3/12
2/8
1/4
Norton 8 and Sharpton 15K
4/16
3/12
2/8
1/4
Handamerican flatbed hone .05 Micron
50 strokes
50 strokes on linen strop
50 strokes on the leather strop
jmsbcknr
WOW, that's a lot of smoothing te edge out. I'd be afraid of smoothing the fins away completely with a set like that.Quote:
Originally Posted by jmsbcknr
X
Thanks Jim,
Its always good to see what works for someone.
Just one question. Is that a "Sharpton" or a "Shapton" hone. They are different.
?Quote:
Originally Posted by jmsbcknr
Quote:
Originally Posted by randydance062449
Shapton. Must have been thinking of the reverend. jmsbcknr
It is certainly different than what I have used before. I actually got it from Dr. Moss and frankly tried it on a razor I had just gotten off of ebay. Did one round and it was shaving like a champ. I will continue to see if there is a difference between this and the pyramids that use more strokes on the 4K and less on the 8K.Quote:
Originally Posted by xman
jmsbcknr
Sorry if this seems a bit of a daft question - when honing using the Pyramid method do you keep the blade angled when drawing across the stone < / like / > ( arrows show honing direction ) or do you go straight across ? I'm guessing this will make a significance differnce to the overall results ?
It is more like </ \> motion... both diagonals going down, and out of the hone by 2/3 rds of the blade lenght.Quote:
Originally Posted by Garry