Hi,

I was working on a 4/8 EAB Eskilstuna frameback, beautiful little razor.

The problem is that the toe would not pass the HHT (but HHTs are fine everywhere after about 1" from the tip.) Everything looks fine under 30x, bevel is (more or less) uniform, but the HHTs just don't work on the toe section. I do the rocking motion, 4K, 8K, strop - nada. Again - several times. Same results.

The razor is very, very light. Is it advisable to just focus on the toe for the next honing session and apply some pressure?

Thanks
Ivo