Thread: Pyramid Schemes!

Greetings hone-meisters,

I've been reading up about the Pyramid method, especially Lynn's tutorial. A couple of questions remain -- maybe I'm striving for excessive obsessiveness, but . . .

1. Lynn describes the pyramid method using a 4k and an 8k Norton -- but I have Naniwa 5, 8, and 12k stones.

Do I repeat the pyramid process on the 8 and 12, after first doing it on the 5 and 8?

2. Lynn discusses holding the razor at a 45 degree angle relative to the stone, but the pictures don't show it. Of the two ways to do so, I assume I should hold the razor so the head leads the heel, rather than the other way round. Is that right?

(I hope it's clear what I mean by this)

Thanks,

Brenton

Hi Brenton,
If you look at gssixguns honing videos, he always uses a heel forward stroke and IIRC Lynn does too.
As far as the pyramid goes, I don't know ('cause I don't use the pyramid method), but you could try it and see how it works for you.
I would think it would only be for the 5/8k as the 12k is a finisher for the final polish of the edge

Thanks Hav',

I'll give that video a look-see. I was trying to "hone up" last night, head first . . . I think I made it duller, not sharper.

Could be my lack of a light touch, though.

I'll assume the heel-first position for round #2, tonight.

Understand that the Pyramid was designed for the Norton 4/8 but yes it does work very well on other stones too..

The objective was to allow a honer to learn to sneak up on the final edge and preventive overhoning...

If I were going to use it with a Naniwa SS 5/8/12 set up I would either go like Havachat45 said and do the 5/8 then finish 12.. Or do a full Pyramid and do 5/8 then 8/12 kinda would depend on how the razor was reacting... Try it one way first and shave a couple of weeks, then go the other route and see what works best for you..
There is really no right or wrong way here...

Hi GS',

Thanks for chiming in! I've been enjoying your videos.

Your point about the rolling X type stroke is, I hope, also going to be helpful, as I've noted both my razors are not dead straight.

I only noticed it when I saw grey build-up on the edge of the stones as I hone. I confirmed it when laying the blade flat on the hones when they're dry -- then I could see that the blades don't lie flat.

Applying Lynn's method , as sixgun said, the 5/8 and finish on the 12k. When I had naniwas I liked to do the pyramid on the 3/5 and finish on the 8k. Lynn and Dylan were doing 5/8 and 12. Going to 12 was icing on the cake. Either way is good but the 12 is strictly for the finishing.

Update:

Ok fellows, I ducked out early this afternoon to work the pyramid, whilst trying to follow carefully from Glen's excellent videos. Test shave, and it looks like I've dulled the blade!

So I think I've got more a more basic problem, and I believe it's the un-straightness of the blade.

I'll need to make something of a study of the ways and means of rolling / x-stroking the blade so as to actually be sharpening it before i return to such advanced topics as pyramids etc.

I suspect that last time I honed my razors, the improved sharpness didn't come from the hones at all, but actually from the pasted T-I paddle strop that I "finished" the blade on.