I'm having tape problems I just wanna make sureim doing this right I'd like to have a even sharp blade so any advice would be greatful
Printable View
I'm having tape problems I just wanna make sureim doing this right I'd like to have a even sharp blade so any advice would be greatful
It would helpful if you told us what the problem is?
Just put one strip of electrical tape one the spine of the razor. Trim so it covers the whole length. Can you be a little more specific about your taping or honing issue?
---michael
I jut wanna make sure I doing it right or how to do it. Like what's the proper way of putting tape on I'm more of a visual guy so it's hard for me sometimes to do as people say without a visual I just wanna make sure the tape is even with no problems. So I would appreciate any advice or videos or anything
I have only used tape once it was kinda uneven towards the shoulder and my honing well there is a lot going in there all I have is one practice razor and I just started honing this week so I'm really new I don't have the turn down and keeping the blade flat on the stone there is a lot wrong with the honing
Any of gssixguns you tube videos shows how to tape the spine.
Watch them all if you can and you'll get lots of good information
Run the tape down the spine of your razor. Start the tape just before the tang becomes the spine and finish a bit off the end. Cut the excess off (a little hang over is ok and helps when its time to remove it) If the spine is centered on the tape there will be equal amounts on either side to smooth over, if its a bit un even thats ok. Be sure that there are no wrinkles or bubles and you should be off to a good start. What kind of stones are you using by the way?
We are talking about honing here, not stropping right? Master stropping first, the lessons learned there carry over to Honing.Quote:
Originally Posted by Tylerbrycen
Yes sir we are talking about honing and the tape is getting easier to use now