Here's one I have. Pretty much like the OP's.
Attachment 330815
Printable View
Here's one I have. Pretty much like the OP's.
Attachment 330815
This sort of goes against your post about hot pressing them.
Hot pressing them and then if they deformed enough to use the hole in the wedge the outside would maybe have to be reshaped.
With that much work done to the scale I wouldn't want them to deform in pinning.
No, I didn't say hot-pressing them. I suggested warm. Anyway, the benefit is friction. Keeping the wedge in place.
Anyone ever seen an oldie with another pin, hidden by a large collar? Same idea.
Yes. Lots of tiny screams were heard as I rummaged through the draw in search of it! :D
For the archive's.
Attachment 330916
A good archive!
Today i disassembled some old razors and came across these two mystery hole wedges.
Attachment 333809
Attachment 333810
Mass produced wedges designed to fit different pinning configurations?
Those holes look like they could accommodate 2 different single pin positions and one double pin.