DC asked if i would try my hand at a str8
so here one is 1of 4
forged W1 1/4 inch thick spine
G10 with iron wood spacer
stainless stop pin
3/16 folder pivot with phos.bronze washers
the blade was flat ground to a wedge heat treated im my kiln quenched in parks (thanks deker for bringing it over for this) cryoed in LN then tempered
i finish ground the blade on 2 inch wheel for that great deep hollow
these pictures are shot before i replaced the pivot screws with new ones (scuffed the ones in it up while shaping handles)
i have not sharpened this one yet but i hope to get that done later today
anyhow here are the shots thanks for looking if your looking for a shot i have not taken yet let me know and i can work on getting the pic taken
there are a few shots of the first one too on my site www.harnerknives.com
feedback welcome as i want to make sure i get everything just right http://www.harnerknives.com/coppermi...DSC04857sm.jpg
http://www.harnerknives.com/coppermi...DSC04854sm.jpg
http://www.harnerknives.com/coppermi...DSC04853sm.jpg