A restored Wm. Greaves & Sons with eagle etching and spine tooling. 15/16" width. Original horn scales replaced with black horn scales.
Attachment 277955
Printable View
A restored Wm. Greaves & Sons with eagle etching and spine tooling. 15/16" width. Original horn scales replaced with black horn scales.
Attachment 277955
I think this is a regrind from a near wedge because of that stub tail.
Slawman
I take back what I said about a regrind.
If you were talking about the razor the op posted in 2009, yes it's reground, and likely the bottom of the tang is reshaped. The restored Greaves "American Razor" is not reground, and such a nice deep original Eagle Etch and Slogan in the scallops of the spine, lovely!
Not sure I can teach anyone anything but here are a few thoughts. In my opinion the best place to start is looking at a LOT of razors, compare them in terms of what you most commonly see vs unusual findings for similar/dissimilar marked and/or shaped blades. read what others have said regarding those blades, shapes, grinds from the particular timeframe for each blade in question (Not everything written here is accurate and many times newer findings clarified earlier inaccuracies or misunderstandings so diligence is required when sifting through old posts here). I've been somewhat prone to jumping the gun myself and have inserted a foot or two into a wide open mouth :fim:
I personally Also look for obvious and blatant differences in surface texture, often regarding tangs and blade faces this can be more readily observed in person than in pics so I purchase an insane amount of blades just to examine sometimes. The level of Oxidation and the pattern it presents in are sometimes telling on more well executed regrinds. Traces of a blade etch under obvious grind lines are a dead giveaway.....
well, I guess after writing this far it will best to post pics for illustration purposes. I'll post a few pics later on.......
read this thread:
http://straightrazorpalace.com/razor...revisited.html
Then some examples of what the op's Greaves may have looked akin to:
http://straightrazorpalace.com/razor...blade-now.html
http://straightrazorpalace.com/custo...lack-horn.html
Regrinds have historical backing and can be beneficial in some cases but discretion again needs to applied here, since it certainly could erase some historical significance doing a regrind and details of a blades origin can be lost. Abating the spread of oxidation, evening up hone wear, making honing an easier task, correcting a fault in a blade. These have all been used as reasons for regrinding.
As seen in some of my pics here a regrind does not always mean hollow grinding a blade either. This is the far more attractive option to someone like me when a regrind is decided upon. If a blade is a near wedge when I commence a regrind it remains a near wedge when I've finished the regrind. As little surface metal removed as possible is my general rule.
p.s, the top pic shows some regrinds along with some hat are obviously hollow ground intentionally, and etched.