Most likely horn. I don't think it is tortoise, doesn't looks like it
Printable View
The caption says those are wedge shaped blades. Perhaps in that book, as on the forum, the term "wedge" is used quite loosely and encompass true wedges, near wedges, and quarter hollows.
That loose definition contrasts with the strict definition in the wiki. - http://straightrazorpalace.com/srpwi...ths_and_grinds
I don't mind the loose definition of "wedge," but it just seems wrong to me to use the loose definition for "true wedge" or "full wedge." True/full, at least to me, implies that you are using the strict definition.
How about discount for ESL? ;)
http://straightrazorpalace.com/attac...s-dscn2768.jpg
Mine is a true wedge. This is a great shaver, too bad scales were not original when I got it, they were black plastic.
holli4pirating
In fact you are right, this is near wedge blade. In Henckels chart shape #II
I did some work on handles, this is how they looks now.
Attachment 132922
Attachment 132923
Hi res pictures, 10mb each. Think before downloading
one
two
Great work on those scales! How did you manage to clean them like that? I love the razor as well!
One little thing, it looks like the blade has a little crack near it's heel :boohoo:
Name of this crack is "age"
(on the question of a regrind) A couple things are pointers. With a blade this old, look at the condition of the blade face. For a razor to have so much pitting and wear on the tang and to be rescaled at some point, it is not consistent with what would be a factory finish on the blade. Also on the tang you can see there is a lot of pitting but the tang still looks ground and shiny. This was apparently somewhat common, to regrind the back areas as well as the blade itself. Also the line between the angles on the tang is pretty rounded. This almost always happens with soft wheel buffing that is done today, but can happen with grinding that does not perfectly set those angles as well. Original pieces would have a crisp line there. Finally, from your second hi resolution picture, it looks like there are two sets of hone wear. This would be consistent with original hone wear and hone wear after a new angle was set by regrinding.Quote:
what makes you think so? it is true wedge BTW
A very clever old repair on the pivot end though. Neat scales, would love to have seen them with their original blade.
edit: saw the recent replies and thought this was a newer thread. My bad
This is 3 years old thread.. That horse is dead already..
:deadhorse: