Search:
Type: Posts; User: Slartibartfast; Keyword(s):
Search: Search took 0.09 seconds.
-
03-14-2009, 02:27 PM
- Replies
- 20
- Views
- 4,313
wikified Easily make a pasted balsa strop -...
wikified
Easily make a pasted balsa strop - Straight Razor Place Wiki -
03-13-2009, 02:06 AM
- Replies
- 20
- Views
- 4,313
Only took me a few minutes to lap it, so i...
Only took me a few minutes to lap it, so i figured i would take the time :)
-
03-05-2009, 06:27 PM
- Replies
- 20
- Views
- 4,313
The plus side is that it is hard not to get the...
The plus side is that it is hard not to get the entire blade. Touched up the razor this morning with it and got a great shave.
-
03-05-2009, 10:48 AM
- Replies
- 20
- Views
- 4,313
Yeah.. so I just used this. I think this is...
Yeah.. so I just used this. I think this is about 4" wide :) You could probably try to find a smaller width of balsa
-
03-05-2009, 03:24 AM
- Replies
- 20
- Views
- 4,313
Thanks! That is your CrO powder on that strop :)
Thanks! That is your CrO powder on that strop :)
-
03-05-2009, 03:22 AM
- Replies
- 20
- Views
- 4,313
I actually took some paper and wiped it down a...
I actually took some paper and wiped it down a couple times to try and get whatever excess i had on there off.
I think i used a bit too coarse a grit of sandpaper too, but it felt smooth. -
03-05-2009, 02:24 AM
- Replies
- 20
- Views
- 4,313
Just a piece of Tile :) I guess i will find out...
Just a piece of Tile :) I guess i will find out if i overpasted.. comment that i'm an idiot if it looks like i did so no one else makes hte same mistake.
-
03-05-2009, 02:23 AM
- Replies
- 20
- Views
- 4,313
Lets mix some CrO powder with a little bit of...
Lets mix some CrO powder with a little bit of mineral oil
21380
Much Better, should spread easy now.
21381
Mark X's all the way down the board and then spread.
21382 -
03-05-2009, 02:11 AM
- Replies
- 20
- Views
- 4,313
The Slartibartfast Pasted Balsa Strop
So... I finally got around to building my own pasted strop. Was easy and cheap. Here is how i did it and the end result.
The Supplies:
I cut a piece of 12x12 tile i had lying around and cut a...
Results 1 to 9 of 9