Search:
Type: Posts; User: TheBaron; Keyword(s):
Search: Search took 0.01 seconds.
-
02-12-2010, 06:52 PM
Thread: Lathe-less Handle
by TheBaron- Replies
- 17
- Views
- 3,077
Going back to the original post... 5. If you...
Going back to the original post...
5. If you ruin it you can spend $7 to replace it with a new VDH brush and bowl.
yea, that happened but I have not replaced it yet. :p
The plastic was... -
02-02-2010, 09:37 PM
Thread: Lathe-less Handle
by TheBaron- Replies
- 17
- Views
- 3,077
Thanks for adding that, I my my knot from The...
Thanks for adding that, I my my knot from The Golden Nib as suggested.
-
02-02-2010, 08:49 PM
Thread: Lathe-less Handle
by TheBaron- Replies
- 17
- Views
- 3,077
Finally got a chance to finish up the hole saw...
Finally got a chance to finish up the hole saw brush handle. I had to make a basic stand as I don't have funds for a matching wood stand right now.
For now a bent rod with attached magnet will... -
12-23-2009, 03:06 PM
Thread: Lathe-less Handle
by TheBaron- Replies
- 17
- Views
- 3,077
I think I will be polishing up more metal plugs...
I think I will be polishing up more metal plugs (Like the one in this handle) and adding it to the back of every brush I buy/make. Then I can make one long magnetic brush stand to hold em all.
... -
12-23-2009, 05:44 AM
Thread: Lathe-less Handle
by TheBaron- Replies
- 17
- Views
- 3,077
OK, after some learning a thing or two the first...
OK, after some learning a thing or two the first time around, I started over and corrected some errors, refined my process, changed the design of my lathe-less brush handle (image attached).
I... -
12-19-2009, 09:14 PM
Thread: Lathe-less Handle
by TheBaron- Replies
- 17
- Views
- 3,077
This handle is made with ebony and wenge without...
This handle is made with ebony and wenge without a lathe, this is just a test so it's completely unfinished. I have figured out some mistakes (first mistake would be not doing my first test with...
-
12-13-2009, 08:55 PM
Thread: Lathe-less Handle
by TheBaron- Replies
- 17
- Views
- 3,077
Lathe-less Handle
I have quite a few ideas for making a brush handle with no lathe as I do not have one. As I get a chance to test these ideas i will put them up.
For those of you that started with a VanDerHagen...
Results 1 to 7 of 7