Search:
Type: Posts; User: Mike Blue; Keyword(s):
Search: Search took 0.03 seconds.
-
08-25-2013, 05:27 PM
Thread: Alls Well that Anv-ells?
by Mike Blue- Replies
- 46
- Views
- 5,466
The traditional measure is standing straight, arm...
The traditional measure is standing straight, arm straight down at your side, and your knuckles of a closed fist just touching the surface of the anvil (anvil plus base). Some folks find this too...
-
08-23-2013, 10:36 PM
Thread: Alls Well that Anv-ells?
by Mike Blue- Replies
- 46
- Views
- 5,466
There is a calculation involved for height of the...
There is a calculation involved for height of the anvil face off the ground that blacksmiths would consider standard, but it's really individualizing the height of the anvil for the most common user....
-
08-23-2013, 05:32 AM
Thread: Alls Well that Anv-ells?
by Mike Blue- Replies
- 46
- Views
- 5,466
Some folks deaden an anvil with a magnet on the...
Some folks deaden an anvil with a magnet on the side. Sand has been used for a long time in anvils of all kinds. I build my anvil stands out of 6x6 timber and inlet the base of the anvil. Works...
-
08-21-2013, 03:48 PM
Thread: Alls Well that Anv-ells?
by Mike Blue- Replies
- 46
- Views
- 5,466
From the close up, and I'm not a welder, but that...
From the close up, and I'm not a welder, but that looks like someone took an arc welder to the edge and tried to repair it by building it up. That is a very common type of repair. All you may need...
-
08-21-2013, 02:13 AM
Thread: Alls Well that Anv-ells?
by Mike Blue- Replies
- 46
- Views
- 5,466
I don't see anything obvious from the pix. Do...
I don't see anything obvious from the pix. Do you have any blacksmiths groups near where you live? Personally I wouldn't commit to an opinion unless I could inspect it close up. I'm pretty sure...
-
08-20-2013, 10:48 PM
Thread: Alls Well that Anv-ells?
by Mike Blue- Replies
- 46
- Views
- 5,466
You won't want perfectly square corners. I've...
You won't want perfectly square corners. I've seen a lot of anvils with slightly different radii on each side to accommodate the smith's choice for inside corners. Tools are meant to be modified....
Results 1 to 6 of 6