Search:
Type: Posts; User: Bruno; Keyword(s):
Search: Search took 0.09 seconds.
-
08-30-2013, 07:38 PM
Thread: Alls Well that Anv-ells?
by Bruno- Replies
- 46
- Views
- 5,466
I doubt that the WD40 is going to work because it...
I doubt that the WD40 is going to work because it sounds like the hardy was tapered and then hammered in a slightly too small hardii hole. In other words, it's not crud holding it in, it is...
-
08-23-2013, 06:30 AM
Thread: Alls Well that Anv-ells?
by Bruno- Replies
- 46
- Views
- 5,466
What do you mean by inletting the base?
What do you mean by inletting the base?
-
08-22-2013, 05:43 AM
Thread: Alls Well that Anv-ells?
by Bruno- Replies
- 46
- Views
- 5,466
That's a nice anvil stand. Did you make that?
That's a nice anvil stand. Did you make that?
-
08-21-2013, 05:38 PM
Thread: Alls Well that Anv-ells?
by Bruno- Replies
- 46
- Views
- 5,466
Absolutely. And sometimes in extremely skilled...
Absolutely. And sometimes in extremely skilled ways.
For example, A certain type of Swedish anvil was hardened by heating it critical, and then dousing it with a calibrated amount of water. The... -
08-21-2013, 06:50 AM
Thread: Alls Well that Anv-ells?
by Bruno- Replies
- 46
- Views
- 5,466
Still wouldn't sand. The advice over at...
Still wouldn't sand. The advice over at 'IforgeIron.com' is to just start using it, as nothing will get rid of rust as quickly as beatin some hot iron on the surface. And you get the benefit of not...
-
08-21-2013, 05:40 AM
Thread: Alls Well that Anv-ells?
by Bruno- Replies
- 46
- Views
- 5,466
Looking good. The chipped corners are to be...
Looking good. The chipped corners are to be expected. I was told by several smiths that you don't want crisp sharp corners anyway, because any slight misalignment of your workpiece would be stamped...
Results 1 to 6 of 6