Search:
Type: Posts; User: Magpie; Keyword(s):
Search: Search took 0.02 seconds.
-
01-14-2012, 04:57 AM
Thread: Because its never too far gone!
by Magpie- Replies
- 27
- Views
- 3,182
I think this is about as good as she's gonna get....
I think this is about as good as she's gonna get.
87349 -
01-13-2012, 05:21 PM
Thread: Because its never too far gone!
by Magpie- Replies
- 27
- Views
- 3,182
Oh Lord no! Even I am not THAT insane! ...
Oh Lord no! Even I am not THAT insane! The carbo was just on hand when I was looking for a background to provide enough "sharp" relief to make the edge more visible in the photo.
... -
01-13-2012, 03:00 AM
Thread: Because its never too far gone!
by Magpie- Replies
- 27
- Views
- 3,182
Isnt that what I said? :p
Isnt that what I said? :p
-
01-11-2012, 09:23 PM
Thread: Because its never too far gone!
by Magpie- Replies
- 27
- Views
- 3,182
Or, the steel is just shallower in the center...
Or, the steel is just shallower in the center on that side, because the rust was so much more severe, that when removed, it left a dent in it!
-
01-10-2012, 11:42 PM
Thread: Because its never too far gone!
by Magpie- Replies
- 27
- Views
- 3,182
Progress report. a bone numbing amount of...
Progress report. a bone numbing amount of honing later, its still not quite there, but it IS close. and I do believe the last pitting will be cleared with just a bit more. 87121
-
01-10-2012, 05:29 PM
Thread: Because its never too far gone!
by Magpie- Replies
- 27
- Views
- 3,182
Anybody have any thoughts or advice on how to...
Anybody have any thoughts or advice on how to proceed from here? How best to minimize the "shiny pits" syndrome?
-
01-09-2012, 09:04 PM
Thread: Because its never too far gone!
by Magpie- Replies
- 27
- Views
- 3,182
Some hand sanding, and some free hand grinding. ...
Some hand sanding, and some free hand grinding. a bit of greaseless just to see what it might look like. The pitting goes fairly deep, I dont think it will be possible to remove it all without...
-
01-08-2012, 10:32 PM
Thread: Because its never too far gone!
by Magpie- Replies
- 27
- Views
- 3,182
Today is hand sanding day. just to get the...
Today is hand sanding day. just to get the rough stuff off and I can take stock of the situation. Razor is stamped...
(unreadable) & J.G. Parker
Universally
Approved Razor
... -
01-08-2012, 04:02 AM
Thread: Because its never too far gone!
by Magpie- Replies
- 27
- Views
- 3,182
Because its never too far gone!
Today I begin my first true TOTAL restoration.
Not even sure what it is yet, but I have decided to name it Fox (Ferrous Oxide) get it?
Poor thing was in the bottom of a toolbox in...
Results 1 to 9 of 9