Search:

First testrun on the buffer with greaseless today, worked like a charm, despite it's low power :D

Just one thing I experienced, because of the short axels it will be easier to work with the same ...

Yup :) I also have a workbech in the basement I use during winter when it's too cold to be in the garage, but SWMBO think I make too much noise so I will probably get a heater for the garage next...

Finally the workshop is fully up and running :D

The buffer is on the smaller side, and a bigger one will be added, but it works for now.
...

Came to think of that I bought some wheels a few weeks ago, dug them out from their hidingplace in the workshop, turns out they are 4" with the right pivot diameter to fit this grinder:

86131
...

Thanks, a little embarassing though, should have thought of the stickies 86094

Lots of good info, just had a quick look now, have to read up a little over the weekend.

Smalles grinder I've found is a 5" that runs 2900 rpm, and the 6" wheels are the only one I have found so far, but the wheels I could order from abroad, guess they're neither expencive nor heavy.
...

Thanks Glen,

I've found a grinder that runs on 2850 rpm with 6" wheels, so if I understand this correct that would make 1,5 x 2850 = 4275 SFPM, which should work okay?

If so, finding the right...

Yes, I know most of you have seen the same or similar before, and many of you have a similar setup in your workshop, and some of you really couldn't care less of what I got in my workshop, but I'm...