Search:

Well Randy, these are mine and will never leave my abode. When I make others that will be offered I have a makers mark in mind. It most likely will be a large letter 'M' and a small tail , if you...

I did happen to tape this one so as not to mar the finish. I did calculate the angle and the tape wasn't a factor as far as the angle was concerned.
Though this does have a wide bevel taping plays...

At this point I just used some A1 and D2 steels. Easy to work , easy to treat. I've been using 3/16 steel. The thing that matters is being able to calculate the angle of the edge based on the width...

I guess I'd feel about the same as when Tim Zowada asked me if he too could copy my designs and give credit where it's due,, flattered

Hi Guys, sorry for the delay but Sandy had me out of commission for a bit.
The piece is deceptive looking. It's 6 1/2 inches overall with an edge length of 2 1/2 inches .

Not a site, but here are some other shots of a variety of things.

Flickr: Mark Yundt's Photostream

My website is for my regular work
www.woodworkingstudio.net

No Adam, I didn't . I did it just like it's done on custom knives and other razors I've seen.

Thank you gentlemen.
Yes, I made the base as well. It's an off shoot of my regular work, woodcarving. Here is another 'stand' I made for my DE's and carved a matching brush, bowl and scales for a...

Here is my first custom. I didn't have a Kami, so I made this one. I know I went in a bit of a different direction than the usual. I did Giraffe bone handles, brass file cut liners, a bit of file...