Search:
Type: Posts; User: McBrautigam; Keyword(s):
Search: Search took 0.01 seconds.
-
05-26-2013, 11:32 PM
- Replies
- 18
- Views
- 2,897
Work is going to be almost nonexistent on this...
Work is going to be almost nonexistent on this for a bit. I just bought my first shave den and got a house with it. Almost done scrubbing everything and then the fun part of moving in and setting up...
-
05-05-2013, 02:54 PM
- Replies
- 18
- Views
- 2,897
I did not use a belt grinder for this. I used a...
I did not use a belt grinder for this. I used a 6" bench grinder. I would like a belt grinder but can't quite see myself getting one yet.
-
05-02-2013, 12:19 AM
- Replies
- 18
- Views
- 2,897
129210129211 I have it ground out now. That...
129210129211
I have it ground out now. That was a learning experience! Once I figured it out it wasn't too horrible. I think I kept it cool enough since I did not burn myself.
As far as heat... -
04-29-2013, 01:27 PM
- Replies
- 18
- Views
- 2,897
It is 1/4 thick stock. That should give me the...
It is 1/4 thick stock. That should give me the 3.5:1 ratio of blade size to spine thickness that I am looking for.
-
04-29-2013, 02:46 AM
- Replies
- 18
- Views
- 2,897
I am aiming for quarter hollow to near wedge. I...
I am aiming for quarter hollow to near wedge. I am using a six inch wheel so, if I rememeber what I read from a post that I cannot find now, I should be right about there
-
04-29-2013, 02:31 AM
- Replies
- 18
- Views
- 2,897
I had time this past semester in my ethics class...
I had time this past semester in my ethics class to doodle a lot on the edges of my notes. I got a 4.0 in the class and a few more ideas for razors. :D
-
04-29-2013, 02:20 AM
- Replies
- 18
- Views
- 2,897
First attempt at making a razor (Work in Progress)
128891
This is O1 steel that hopefully will end up as about a 7/8, or close to it, razor. I forgot to take picture of cutting it out but I did it by marking the outline on the steel and the...
Results 1 to 7 of 7