Search:
Type: Posts; User: BobH; Keyword(s):
Search: Search took 0.08 seconds.
-
12-10-2013, 02:13 PM
Thread: Setting A Bevel
by BobH- Replies
- 24
- Views
- 2,507
There will always be a few razors that will give...
There will always be a few razors that will give you a hard time honing them be they used or new. It is good to stop when you get a bit frustrated too. I doubt very much that you ruined that Dovo...
-
12-09-2013, 12:00 AM
Thread: Setting A Bevel
by BobH- Replies
- 24
- Views
- 2,507
Lets try this another way then. Is the bevel a...
Lets try this another way then. Is the bevel a uniform width on both sides? I am going to guess that on one side there is a spot that is wider than the the rest of the bevel on that side. On the...
-
12-08-2013, 09:54 PM
Thread: Setting A Bevel
by BobH- Replies
- 24
- Views
- 2,507
A photo of both sides of the blade would be...
A photo of both sides of the blade would be helpful to see what is going on. It is hard to visualize what you are saying.
Bob -
12-07-2013, 04:49 PM
Thread: Setting A Bevel
by BobH- Replies
- 24
- Views
- 2,507
To me it means that the bevel runs out to the...
To me it means that the bevel runs out to the edge on both sides but it may not mean the bevel edges have actually met, if you get what I mean. You may need further honing on the bevel setting hone...
-
12-07-2013, 03:00 PM
Thread: Setting A Bevel
by BobH- Replies
- 24
- Views
- 2,507
I'd have to go along with what RezDog is saying...
I'd have to go along with what RezDog is saying as that is what I do also when setting a bevel. I have also used a DMT plate on a couple of really bad blades and like Bill says it takes a lot of work...
Results 1 to 5 of 5