Search:

Yes wet, get a large cookie sheet from the dollar store, lay your Wet & Dry on the sheet and set it on the ground on a flat piece of concrete, Garage floor works. Flood the sheet with water and the...

No, don’t use the Harbor Freight diamond plate, they are too rough and the diamonds are too inconsistent.

Chef Knives to Go has a nice dual grit 400/1k diamond plate that is great for blade...

So lots of issues with the blade and edge first clean the blade with WD40 and 000 steel wool or all that rust and grit will end up on your strop and eventually affect the edge.

The toe is crooked...

As Shaun said two different things, when you look down on the edge you are looking for the meeting of the bevels, if you see reflections, the bevels are not meeting. If they are you can’t see it, you...

Yea, probably the bevel was not set, common after bread-knifing, especially with a stone of unknown grit or quality.

Look at the edge, straight down. If you see any shiny spots re set the bevel,...

Take a look at this thread, 12K Chip Removal/Bevel Setting.

Breadknife, removed a chip and 80 circles and 206 laps, to a fully set bevel and shaving, on a 12K Super Stone.

So what you are...

So, what you are doing is really not much different than what guys have done for hundreds of years, bevel set on a low grit stone of undetermined grit and polish on a higher grit stone of...