Search:
Type: Posts; User: taz575; Keyword(s):
Search: Search took 0.01 seconds.
-
07-03-2014, 09:43 AM
- Replies
- 12
- Views
- 1,209
Yeah, my problem was that the little washers/cups...
Yeah, my problem was that the little washers/cups didn't fit over the end of the pins, so they kept popping off when I would hit them, so I tried w/o the washers and that sucked. So I got lots more...
-
07-03-2014, 02:37 AM
- Replies
- 12
- Views
- 1,209
Sad to say, but that was scrap buckeye burl! I...
Sad to say, but that was scrap buckeye burl! I had used the rest for a kitchen knife handle and had this long, thin piece left sitting in my drawer of scraps, so I split and flattened it for scales....
-
07-03-2014, 01:07 AM
- Replies
- 12
- Views
- 1,209
I ordered some more pinning stuff and also found...
I ordered some more pinning stuff and also found some pinning stuff and washers at McMaster Carr. I also found tiny little nuts and 0-80 threaded rod, so I redid this one with the threaded rod and...
-
06-16-2014, 07:14 PM
- Replies
- 12
- Views
- 1,209
Yes, it was stabilized, I believe it was K&G...
Yes, it was stabilized, I believe it was K&G stabilized. It was a leftover piece of the block I used for a knife handle a while back. Some of the blocks are wider than I need and I am left with a...
-
06-15-2014, 12:27 PM
- Replies
- 12
- Views
- 1,209
IIRC the scales are around 3/32"up front, maybe a...
IIRC the scales are around 3/32"up front, maybe a bit less, 5/32" towards the middle and taper back down in the back. There is good flex in the front end, but not the back. Where the pins are is...
-
06-15-2014, 01:51 AM
- Replies
- 12
- Views
- 1,209
Some pics I took inside. You can see the crack...
Some pics I took inside. You can see the crack near the front pin in the closed pic. Will making the scales thinner and using a wedge help with the tension issue? Or should I go to 2 pins on the...
-
06-15-2014, 12:29 AM
- Replies
- 12
- Views
- 1,209
Tried my first set of scales and pinning...
Well, I was in the shop and decided to try a set of Buckeye Burl handle scales out of some scrap for the Magnetosteel razor that I shorted by 1/4" or so. I used a .090" thick ivory Micarta spacer...
Results 1 to 7 of 7