Search:

I did it! :y :y :y

As I told the blade was too fat after reduced its width. After tried many times the heavy bevel set which was for hollow and semi hollow razors and for the wedges which did,not...

I see, well what I did at first was the correct the crack at 90 degrees on the dmt so I had the butter knife. After that, I started to reduce the angle of the blade ( still on dmt), at the moment I...

that's what i exactly did at start when i corrected the crack. but my blade is not a hollow one, so even if i decrease the angle after butter knife level, the bevel does not touch at all to hone if i...

well i found a solution, as i said this was a 7/8 wedge with a big crack (almost 2 mm) in the bevel which i corrected. but here is the problem, at least, as the blade lost of largeness there is a...

as i said earlier yes i tried butter knife when i deleted the crack

i think when i corrected the crack (about 1.5 mm) the blade lost a lot of his large. i think i just need to regrind it (well i don't have grinder) or continue on DMT because the edge is still not...

here some pics,

just marked the edge with black pen

222344222345

and here, after few passes on 400 grit. as you see there is fine draw, the black mark is gone. but below this line, there...

you just resumed well my problem. the spine is 4 mm and the blade is 20 mm large.

i did exactly the same on it, it had a big crack on the bevel so i did not have any other choice than this procedure. the blade has no smile, it is fine and plane with no cracks or micro crack in the...

I mean it works on hone wear but not on the bevel

Yes,I watched some. But with 20/+ layers tape is kind,too,much I think. I already honed many razors but this is thug one. For the picture, you can see them im the first link

Hi earlier i mentionner a razor in here http://straightrazorpalace.com/razors/124686-wedge-microtome.html

Tonight I tried to shave but it,was awful. So I retried to hone it on 400 grit but before...