Search:
Type: Posts; User: CatMan; Keyword(s):
Search: Search took 0.00 seconds.
-
10-18-2007, 09:53 PM
Thread: Straightening bent pin
by CatMan- Replies
- 21
- Views
- 2,007
I usually cut the pin with a thin (0.2mm)...
I usually cut the pin with a thin (0.2mm) separating disk [the one on this photo is 0.4mm]. Then - lately - I trim it even further down with a hard rubber wheel. Seems to work.
I just re-pinned... -
10-18-2007, 06:33 AM
Thread: Straightening bent pin
by CatMan- Replies
- 21
- Views
- 2,007
When I stumbled over this thread, I was hoping...
When I stumbled over this thread, I was hoping there was a shortcut. No such luck, huh? :mad:
I often make the mistake of cutting the pin not short enough before I start peening. Then of course I...
Results 1 to 2 of 2