Search:
Type: Posts; User: Sticky; Keyword(s):
Search: Search took 0.02 seconds.
-
03-10-2009, 12:59 AM
Thread: DMT Question
by Sticky- Replies
- 18
- Views
- 2,200
I use a piece of hardened steel. Usually either a...
I use a piece of hardened steel. Usually either a piece of tool steel or the flat body of a chain breaker. A chisel body is another good piece to use, anything hard and close to flat is good. Use...
-
03-09-2009, 12:52 AM
Thread: DMT Question
by Sticky- Replies
- 18
- Views
- 2,200
IIRC, DMT says the polka-dot hones are more...
IIRC, DMT says the polka-dot hones are more aggressive than the plates. I haven't noticed any practical difference, and I have 7 polka-dots and 4 plates. I haven't hung any sharp points or spikes in...
-
03-07-2009, 11:16 PM
Thread: DMT Question
by Sticky- Replies
- 18
- Views
- 2,200
Since you're thinking about getting a separate...
Since you're thinking about getting a separate D8C, have you seen this sale package yet? $60 for 3 2" x 6" hones in F 600, E 1200, and EE 8000.
This way only one hone in 325 and, so far, this is... -
03-07-2009, 07:28 PM
Thread: DMT Question
by Sticky- Replies
- 18
- Views
- 2,200
Just to be contrary: I like the 2" x 6" hones (or...
Just to be contrary: I like the 2" x 6" hones (or smaller, see avatar) for honing. But then I've been sharpening knives and other tools on smaller hones since I was a lil' fella'. If you're not sure...
Results 1 to 4 of 4