Hey Mate, I do like those French razors....very classy !!Quote:
Originally Posted by Substance
Printable View
Hey Mate, I do like those French razors....very classy !!Quote:
Originally Posted by Substance
I don't know whoever..................these days, they're usually foreigners looking to get citizenship & then they give 'em the boot!:roflmaoQuote:
Originally Posted by whoever
white it in to the vows, some where along side "obedient and obey and will never leave and will make a good honest attempt at replacing man's best friend ":rofl2:Quote:
Originally Posted by engine46
There ya go! I'm with ya on that one. Yeah & the only way they can make a good honest attempt at replacing man's best friend is being a good lover! They might make a good honest attempt at being faithful if ya find the right one.......................:beer1:Quote:
Originally Posted by whoever
I hear the asian ones cook :rock: but cost a pretty penny gettin them here, don't they have k2 visa prenups :-)
:hmmm: I'd have to check into that. My neighbor is from the Philipines & he told me if I had the money he would go there with me & help me find a good one to bring back...................Quote:
Originally Posted by whoever
A nice Day it was today, got two fine Razors,
a John Bingham (polished it a bit and greased the Scales, had a Nice Shave with it a hour ago, its a 11/16"+ Wedge)
Attachment 202217
and i traded my DePew and got this Malteser 15/16" 3/4 hollow for it, had to fight against a bit Rust but i like it.
Attachment 202218Attachment 202219
I received notice that my bottom dial has been re-plated and is on the way!:)
Attachment 202221
It was really rough, with whiskers and dried shave cream, took a few laps through the Ultrasonic before it would operate and had some corrosion and a lot of brassing and did need the plating work after I cleaned and shaved with it.
~Richard
I just got a pound of nickel rod in the mail today, a total of 29 36" rods. It was a lot cheaper than buying it in pinning kits plus I found a place that has the stainless washers that are 2.99-3mm OD. The rod is also a tad harder than what I have bought in the past in pinning kits so it won't bend so easily like the rod I was buying previously which I'm happy about that! I cut a small piece off & I placed it into my 1" square key stock which I have some pre drilled holes in & I usually put a head on one side first, then place a collar on it which makes it easier to tap the opposite end of the piece of rod with a collar on it & is perfect, so much better than what I was getting.:rock:
Dammitt, Steve! My rough math says you can pin 1044 razors using a inch each. That figure may or may not increase as you count in shorter pins and collateral damage. Good Show! :tu
