Roberts Warrented

[gooser]

picked this one up , gonna need some edge work , some rust removal , and some scales !! Unfortunately these scales are trashed as cool as I thought they were !! was able to save the original washers so hopefully they will clean up well and go nicely onto the new scales after they are complete !!

[Trimmy72]

Nice find gooser. Hope I can find a blade like that someday...
other than no heel and a stubby tail, I can only imagine that style of blade would work very nicely and I would never miss the heel.

[engine46]

Here's my Roberts Warranted shave ready. I don't think those are the right scales though. I need to make some new ones! I hate when people polish so much that it takes more off the blade. I would much rather it were a little less polished or no polished at all. It's still a good shaver!

[gooser]

Here's my Roberts Warranted shave ready. I don't think those are the right scales though. I need to make some new ones! I hate when people polish so much that it takes more off the blade. I would much rather it were a little less polished or no polished at all. It's still a good shaver!

ya this one is gonna end up polished up , has some deep pitting and serious rust in the pits that I would really like to get out and stop any further damage!!! Not to mention some pits near the edge by a chip so hopefully it will take an edge after the dings are taken out

[engine46]

ya this one is gonna end up polished up , has some deep pitting and serious rust in the pits that I would really like to get out and stop any further damage!!! Not to mention some pits near the edge by a chip so hopefully it will take an edge after the dings are taken out

Yeah, I figured that was why mine was done that way but if polishing a blade, I would leave the makers mark alone. When I had a guy regrinding for me, i would tell him to try to leave the makers mark intact. I haven't heard from him in a few months now because the last time I had a message from him, he said that he wouldn't be able to do much for awhile, that he had some family issues. I don't know what it was though, I don't pry into other peoples business.
I'm sure he'll surface one day.

[gooser]

Yeah, I figured that was why mine was done that way but if polishing a blade, I would leave the makers mark alone. When I had a guy regrinding for me, i would tell him to try to leave the makers mark intact. I haven't heard from him in a few months now because the last time I had a message from him, he said that he wouldn't be able to do much for awhile, that he had some family issues. I don't know what it was though, I don't pry into other peoples business.
I'm sure he'll surface one day.

ya most of this is gonna be left alone , im gonna hand sand and and just try to blend anything deep into the rest of the razor ..

[engine46]

ya most of this is gonna be left alone , im gonna hand sand and and just try to blend anything deep into the rest of the razor ..

Yeah, I have a lot of blades that need some new scales made including the Rberts Warranted. It just isn't right to be left that way but I did get a smoking' deal on it!