Thread: Cleaning mould off my strop

After a protracted period of rain and flooding here in Australia, I had occasion to go to my shed and found, much to my chagrin, that my black latigo strop is covered in black/green mould.
In my defence, I usually have placed in back into the plastic cover that it came in after using it but this time I forgot and it has now come back to bite me.
I cannot replace the leather because Star Shaving is no longer in existence, I believe.
Any suggestions as to how to clean it up or should I look at just replacing it?
TIA

Man that sucks. I think I would wash it well with saddle soap and let it dry well In the sun.

I think Paul's suggestion is probably a good way to proceed. I had one of mine start to mould up a bit recently but it was pretty minor: it was in the wardrobe rather than in a shed. I applied a vinegar soaked cloth to the affected area.I meant to give it a neatsfoot oil treatment afterwards but forgot and when next I looked at it all seemed well anyway. Keep us posted but maybe see if any other suggestions come in.

I don't like saddle soap. It's made for thick, tough rough duty leather like...saddles for instance. It also requires water which is an enemy of most leather. There are products for leather care containing materials that will clean and protect the leather and that's what I would use.

Check out the Bicks line of products or leatherique which is very expensive but works great.

You can apply 70% Isopropyl alcohol to a strop with no ill affect. It should kill most molds and clean it as well.
I use a paper towel folded up to a small square the turn the bottle upside down in a few spots next to each other then wipe entire strop. It dries very quickly but I normally let it rest before using.
It will make it a little faster in use.

I would clean it with saddle soap or something to clean leather shoes with. After that I would use a leather conditoner to nourish the leather. I would let it dry slowly, not in the sun. Drying too quickly might cause cracks or wrinkles in the leather.
If you get wrinkles you can iron the leather with a wet tea towel between iron and leather. Start at lowest heat and work your way up the heat ladder slowly and checking the results of every step before you increase the heat.

Originally Posted by stoneandstrop

You can apply 70% Isopropyl alcohol to a strop with no ill affect. It should kill most molds and clean it as well.
I use a paper towel folded up to a small square the turn the bottle upside down in a few spots next to each other then wipe entire strop. It dries very quickly but I normally let it rest before using.
It will make it a little faster in use.

I happened to have some Isopropyl alchohol. I keep 50% in the bathroom and 99% downstairs, I use it to clean my fingers before i take my sugar.

I wiped my strops down with it on a cotton wool ball using the 50% and then palm rubbed them after a few minutes. I didn't have mould but felt that they could benefit from a clean. I even used it on my leather CroX stop and managed to remove most of it, it went almost back to black so I applied a fresh coating of CroX.

I have nice clean stops now and I like the alcohol better than a damp cloth.