100th time asked but still - whashers check before purchase

Let me apologize in advance :shrug:,.. I know that it has been asked a lot and that there is a tone of posts, after looking at them I would like to be sure before buying. I prefer to use 0.80 torx screws (the thread part is 1.52mm thick) I use 1.5 or 2mm brass rods also. I am still a bit confused with US washers sizes, so if some one would care to answer the 3 questions below that would be great..(thanks)


1.) peening brass washers (would have to fit screws as well!): FWB0 - #0 - Flat Washers - Brass - Micro Fasteners )

2.) pivot brass washers (the pivot is usually 2 mm may be a little less) (which do you usually use, I guess you have to additionally flatten them with a hammer in every case?) I was thinking of getting these -> FWBW0 - #0 wide - Flat Washers - Brass - Micro Fasteners

3.) which washers would you recommend to buy for making a 3 stacked washers (made of eg 3 washers, not a 1 punched washer that looks like 3), when I did this with ss washers I got locally the problem was if the holes (inned diameters) were different sizes, is there a possibility of getting 3 outer diameter gradual sizes with same (eg 1.5-2 mm) inner diameter?

thanks a bunch

I'll show you a photo of a razor I pinned using FWB0-#0 washers on the top and the FWB0-#0wide on the bottom, and 1/16 imperial or 1.5mm metric brass or nickel bar as this will give you a better idea as to the size and scale.

http://i713.photobucket.com/albums/w...7.jpg~original

@celticcrusader: thanks for the help, that peen looks great, if I won't be able to find a 3 washers combo this is the one i will go for :)..

edit: so does this mean numbers 1.) and 2.) from my 1st post are correct... ?

Yes those are the correct washers.