Printable View
Just started doing my next restore, a Schumate 5/8 full hollow.
This one arrived with a set of black plastic scales in fairly good condition.
Bevel looked good with no nasty gremlins to be seen, just a small chip in the edge near the toe end
It would remove arm hair at skin level with a little pressure.
Pics below of how it arrived
Attachment 144868
Attachment 144869
As I took it apart I broke one of the scales because I was too rushed doing the job
Dumb mistake, pushing too hard when I should be going slow and steady
So a new set of scales will be made to go with the restored blade
Not going for a super shiny brand new look on this one, I want to try a satin finish if I can find the info on this.
I know its here somewhere, just need to find it
A couple of progress pics for those who like them :)
After 400 grit wet/dry
Attachment 144873
Attachment 144872
After 600 wet/dry
Attachment 144874
Attachment 144875
After 800 wet/dry
Attachment 144876
Attachment 144877
Decided to make the scales for this razor, nothing too elaborate
A set of white acrylic scales and matching wedge.
Then did the mock up fit, this part seems to be OK, pics below
Attachment 145075
Attachment 145076
Attachment 145077
Having trouble trying to get a satin finish on the razor
Tried using a scotch brite pad from SWMBO's kitchen supplies
So far just getting what appear to be deep scratches on the razor
Wondering whether some fine steel wool may be a better option
Attachment 145081
Attachment 145082
Finished result in Custom built & Restorations
Went without the Satin finish, maybe try again after some testing.r
