Duracraft Belt / Disc Sander Model 30636

[DaveN]

I acquired a Duracraft Belt and Disc Sander Model 30636
Missing some parts as in the motor pully and belt housing (Housing not really needed).
Have to test the motor as well. Any one have one ? Can we make one out of two for one of us ?

[10Pups]

You should be able to find a pulley that would fit it. I assume the belt is missing too ? If not then figuring out the right size pulley should be easy enough. Otherwise go with your best guess and suffer having to change later if need be.

[DaveN]

The only part I need (assuming the motor is good and it is not attached to the sander) is the pulley that goes on the motor. I have the belt ! The table that goes in front of the disc sander is also missing.

[10Pups]

Well, measure the shaft on the motor and take note if it has a key way or not. If it does you will have to know how wide it is. Then you just need to type that into a goggle box and hit enter. Example: 4" belt pulley for a 5/8 shaft with a 3/16 key way. You may only get 100,002 hits but I am sure you could find one out of that. The table you may have to make or buy something close and retro fit it. I can't find much info on that model sander except your inquiries across the ,so, you may be stuck with figuring out which belt you could use and then searching it out.