Part numbers for stacked washers

[Bamasamson]

I was wondering if any of you fine folks would happen to know the part numbers and a place to get the washers for a stacked washer pinning? I have looked myself but cannot make heads or tails of it.

[Bamasamson]

I guess I am asking the wrong question. What are the sizes of washers normally used in the stacked washer pinning or "bee hive"?

[AirColorado]

There's a thread in here somewhere (been a few weeks) where Glen gives the part numbers from MicroFasteners. I'll try to find it.

I ordered them (plus a bit more) and it all looks about right. Haven't had a chance to set any up on scales yet but they stack up correctly. ...they're a little counterintuitive though since it seems washers of different material and the same size code are actually different sizes.

[AirColorado]

Here's what I found searching here... not sure which may answer your question, the one I got info from is buries deeper.

I think this is the one - post #12
http://straightrazorpalace.com/works...fasteners.html

Here's some others...
http://straightrazorpalace.com/works...fasteners.html

http://straightrazorpalace.com/works...-purchase.html

[10Pups]

http://straightrazorpalace.com/works...fasteners.html

Oh it was in Aircolorado's anyway that's the one I used

[miha]

the codes for microfasteners I ordered were
FWS00, FWSS0, FWSW0, FWBW0, FWB0

the ss are (were) available in 3 gradual sizes, brass in 2 only (lacking the middle one I think, the bigger is the "pivot-tang size washer")

hope it helps

[Bamasamson]

Thanks yall