It seems that most in the knife handle forums will plow though wet\dry sandpaper up to 2000 grit with fiberglass polish at the end.
Is this the preferred method people here have found as well?
Printable View
It seems that most in the knife handle forums will plow though wet\dry sandpaper up to 2000 grit with fiberglass polish at the end.
Is this the preferred method people here have found as well?
Well, wet/dry paper 600-2000 seemed to do a good job.
Maybe a little wax burnishing and call it good...
Getting the scratches out in G10 is the most difficult task. I spend most my time on the lower grits up until 600. Then I move on to 800, 1000, 1500, 2000, 2500, 3000, followed with white rouge on my buffer. If I see any tiny surface scratches left I go back to 400 or 600, depending the depth of the scratch, and move back up again all the way to the buffer. This is what works for me.
I'll have to get a bright light and see how I did. This material sure has a great feel when sanded to the high grits.
I've found the polishing compounds designed for metal work well on G10. If I want a high gloss finish I hand sand up to 1200 grit then buff.
Don't work with it much,as above is nasty stuff.When I have I will sand to 800 grit,than polish with rottenstone and oil.
Attachment 192966
I mainly sand G10 on a belt grinder, but did it a few times by hand too. Basically sand to the highest grit you are comfortable with, than buff with a metal buffing compound, no need for anything fancy. The less you have to buff, the more detail stays, and your corners and edges stay nice and sharp.
Wet sand and with water and then throw out the water; carefully like down a drain, not onto the lawn. The little pieces of glass fiber will be in the air forever and pets will have the problems. Ditto if your kids and pets hang out in your shop.
Paying a price
~Richard
Thanks for all the input and ideas. I had read the dust was bad so a respirator was in use... I did use my sandpaper wet as well to keep dust down.
Hoping to get a wedge made and pin up a blade next weekend. So far the results are as good as I'd hoped.