Printable View
Hi, I'm thinking of purchasing the razor pinning kit from Maggard. Has anyone ever used this kit? The description says the rod is 1/16", but the title says "Brass Razor Pinning Kit(1/8").
Does anyone know the score? Is the rod 1/16"?
I have an email in to Maggard, but I'm sitting at the cart page waiting to punch "proceed to checkout". :D
Sorry,, never used one,,,
I use it. It's called a 1/8" pinning kit because the washers are 1/8" diameter on the outside. He also sells a washer size bigger, but it's not listed at the moment. It's a great kit for pinning razors.
While I've never used the 'KIT' in question; my dealings with Maggard Razors have been 100% POSITIVE Transactions!
Great Customer Relations and Support!
A BIG PLUS for me is that it's a Cottage Industry with Brad and Casie running it.
I Highly Recommend Maggard Razors as a place to do business with! :tu
I've used there pinning kit and they have bags of washers and rods in 12 in lengths and you can cut the pins to length you need. when I order the kits I useally get the brass and the silver kits so no matter what razor I repin I will have the right material excluding the ones with the large bulls eye washers on the outside. Good bunch of folks to deal with.
I too have used the kit. Exactly what is needed.
It's a good kit. The 1/8" size is the size of the washers. The rods are 1/16".
Make sure that you clean the end of your hammer before peening. Any rust on your hammer head will transfer to finish on the pin.
Good advice :tu However I'd be sure to take it a couple of steps further and start with some 220 grit wet n dry sandpaper and go up to 2K to have the head AND the surface highly polished. Any 'dings' on the ball or the plate will transfer to the much softer brass.Quote:
Originally Posted by criswilson10
You could find a small steel block locally or you could pick up an already polished jeweler's block at Amazon (I'm pretty anal about some things so I'd probably see if I could get it even more polished) :shrug:. It doesn't need to be huge. Remember when pinning it's tap, tap, tap, not Bang, Bang, Bang.
Enjoy the Ride :y
I have used his kits also & they are great. I have also purchased from Micro Fasteners but they don't have the small stainless washers. I have found them at another source which is most likely where Brad gets them because they appear the same.
good kit can't fault it! i have used both silver nickel and brass from them, it works, they provide exactly what they say and the service was outstanding as well. a very well run business.
i also got a shaving brush from them as well, decent postage to Australia to!
Thanks for the replies, guys. I have both the brass and nickel kits on the way as we speak. Brad Maggard responded to my email within 20 minutes of receiving it.
Love Maggard Razors! :D