Union Spike - large washers needed

I think you could use flat washers slightly domed also if you cant reclaim them as they are a fairly flat washer
these are Originals on mine from a different angle
Attachment 206660

Quote:

---

Originally Posted by Substance

I think you could use flat washers slightly domed also if you cant reclaim them as they are a fairly flat washer
these are Originals on mine from a different angle
Attachment 206660

---

A small ball pein hammer and a block of hardwood endgrain up will do that job. Hit the ball pein hammer with another hammer to dish the washer below it.
I often used parts of this set to make whatever washers I wanted:
harborfreight.com/25-piece-doming-block-and-punch-set
One of your cheapo stores should also carry them.
~Richard

Thanks gents. My first goal is to remove the scales by drilling out, without damaging the original collars. As already stated though, it's good to have a plan B. Spares would be good to have. Suppose if I ruin the originals, I'll have to get creative!

Quote:

---

Originally Posted by sharptonn

Save the collars by drilling the pins in the middle. Re-use them!
Here is how I drill them in the middle, beginning in post 27 of this thread: http://straightrazorpalace.com/works...le-halves.html

Other ways to do it in the workshop sticky's as well.

---

This was great. Very good tutorial sharptonn. Thanks.