1st Try at Restore - 6/8 S. Littman Spanish Point

Hello everyone,I'll start by saying that i have truly gone "all in" with the straight razor art. In that vein, I recently picked up a 6/8-inch S. Littman Spanish Point for one Andrew Jackson. I purchased it because it didn't look too bad in the sellers photos, the edge looked nick free, and figured I could try my hand at restoration. In all the restoration photos below, I have hand sanded the blade after unpinning the scales.


This is my first restoration attempt and here are some photos of the razor as I received it from the seller:

Attachment 236988Attachment 236989

Here is a photo of the blade profile and a photo on the Straight Razor Ruler:

Attachment 236993Attachment 236994

Here are some photos after the following sanding progression (400/600/800/1K/1.2K/1.5K/2K Grit Silicon Carbide paper):

Attachment 236997Attachment 236998

The photos are not the best, but it's starting to look much better than when i received it.

After all this work, I noticed that the blade has a two-tone variation along its face (as illustrated in the photo below):

Attachment 236995
You can see a duller color on the face of the blade near the toe and a shinier color as you move further back. My guess is that my sanding work is not up to par, but wanted to get some confirmation from the folks who really know how to restore and have probably seen this before.

Any and all help is greatly appreciated.

Looking good. :) You should start sanding up and down to get those length-ways scratches out!
So I believe that is a square-point?

Looking good. Keep sanding and alternate the pattern. Go heel to toe with 1 grit then spine to edge with the next grit until the scratch pattern from the previous grit is gone. Its a lot of work. If you really like doing this a buffer will make your life a lot easier. I don't recommend using a dremel, to many mishaps. The workshop section has a lot of hand sanding information. Keep plugging away, doing fine.

Quote:

---

Originally Posted by sharptonn

Looking good. :) You should start sanding up and down to get those length-ways scratches out!
So I believe that is a square-point?

---

Thanks for morale booster! I thought Spanish Point and Square Points were interchangeable terms......perhaps I have picked up some misinformation in all the reading I have been doing lately!!

Quote:

---

Originally Posted by Hacker7

Looking good. Keep sanding and alternate the pattern. Go heel to toe with 1 grit then spine to edge with the next grit until the scratch pattern from the previous grit is gone. Its a lot of work. If you really like doing this a buffer will make your life a lot easier. I don't recommend using a dremel, to many mishaps. The workshop section has a lot of hand sanding information. Keep plugging away, doing fine.

---

Thanks for the kind words and advice. I am doing everything by hand since we are in a rental home right now and my tools are in storage until my our new home is finished (not that I have a buffer). Plus, it gives me some solo time to work on something I enjoy and it gives me an appreciation for manual work just like it was done in the days when straight razors were the only thing you could shave with.......