Thread: Putting new scales on...help?

So I've recently restored a Boker I found at a local antique shop. My wife and I exchanged 1 gift early and she got me the scales I really wanted for this razor! I've only put new scales on 1 razor before and that was like 5 years ago...These beautiful ram horn scales don't seem to have a pin hole where the blade is attached...Am I going to have to drill the hole too? Or am I missing something?

You are going to have to drill the hole. Try and lay the razor on the scale and line up the hole and mark it where you want it. Most razors are around 3/8" from the pivot end, but depends on how close you want the toe near the wedge. Just don't want it hitting the wedge. If you don't want to remove the wedge pin you could try to place something in between the scales to level them out to be able to drill evenly through them, which is a PITA. Not sure what the liner is, but take it slow drilling through those. Those look like they might be quite heavy and might throw off the balance some. If they are really long that might throw it off more. The wedge looks like it might be a spacer also instead of a wedge and if you decide to remove the wedge pin I would make the spacer a wedge if that is the case. Just take it slow.

I agree with the above post. It is impossible to tell from pictures, but the scales may not have enough flex, which is why there is a spacer instead of a wedge. If you take a vintage razor and go from closed to full open, they will notice that the scales flex throughout the range, and it produces an even tension on the pivot all the through the range. As the scales loose flexibility you also loose the even tension on the pivot, the result is loose points in the movement. I cannot stand scales that are loose it the straight open, stropping, position.
I have no idea what you remember about pinning. If you need some advice on that feel free to let us know.

The most important thing is to drill a straight hole.
Easier said than done without a drill press.

Maybe get a pro of some sort to drill the holes for you?

They do look a bit thick. I agree with all that has been said. Stick the blade in the scales and see where the hole needs to be. Scales are not one size fits all. These may or maynot work for the blade you have in mind. Just be 100% sure before drilling.

Geezer has posted this many times, and works every time.
But a drafting compass will put your blade right where you want it.