Hi Gents.
So, I tried search, read the stickies, etc., but can't seem to find answers to two questions - please help a newb to razor restoration.

Question1: I bought the 1/16th brass rod, I have washers on the way. When I go to install the rod and peen the end, how do I get the other side to stay put and either not be too short, or too long? Do you pre-peen one of the ends? I can't seem to visualize how you would do this.

Question 2: When you are putting CA on scales, I'm assuming that they go all over the scales (inside and out). How do you do that and hold the scale at the same time? Use a latex glove (I would assume though that you'd either get glued to the scale or leave unsightly finger marks?). Again, I'm having problems visualizing this.

Very sorry if this has been covered elsewhere (it probably has), but I couldn't find the answer to these.

Thanks in advance!

Mark