Thread: Tapping pins

Good way to describe it! I pinned my first razor and tapped too hard and bent the pins a bit... I didnt think it would be so soft....

Pivot hole size is the one thing that I haven't seen motioned yet on this thread, reading Toolarts post and the description of the bend in the pin, I would guess that perhaps the pivot hole on this razor might be a wee bit oversize, or when the razor was assembled years ago that it had a slightly longer pin installed from the factory... Causing the bend in the first place.... The one problem is that, as Toolarts found out there is no way of knowing of the problem until either the razor is disassembled during a restore, or "disassembled" after he tried to tighten the pin....