mono scale blank size?

[L R Harner]

so i got on a whim today with a bit of off cut wood from another project

what would a good size be for mono scales blanks (both for me to have on hand and to maybe sell later )

right now i have one just over an inch tall x5 7/8 long and 3/8 wide (sides are 1/8 each and a 1/8 groove in the middle )

so would i be able to get most razor to fit into a block like that ?

if so i will keep it in mind for other cut offs from knives
thanks
Butch

[floppyshoes]

That's just about the right size. Depending on how you choose to cut the slot, you could get away with a little thinner than 3/8". I use a thin kerf tablesaw blade, but you could make a narrower slot with a band saw or by hand.