Results 1 to 4 of 4
Threaded View
-
09-16-2009, 01:14 AM #1
1/16"...1.6mm...should be close, but no.
Out looking for pins to finish up a resto job. I got some 16 gauge brass wire since it was 0.062992" and a 1/16" pin is 0.0625" so they should be about the same.
I got home and clearly neither is going to fit properly...there's a bit of gap between the pin and the hole in the blade and scales. So here's the question: Does the pin expand internally while it is being peined or is this a freak that does not take a standard 1/16" or 16g pin?