Results 1 to 10 of 13

Thread: Wedge angle

Threaded View

jreiter22 Wedge angle 09-19-2009, 03:03 PM
gssixgun Having never seen Ellis' dvd... 09-19-2009, 04:15 PM
ben.mid Here's a photo of one of... 09-19-2009, 04:28 PM
jreiter22 Wedge angle 09-19-2009, 04:33 PM
gssixgun In the same sticky is a link... 09-19-2009, 04:37 PM
jreiter22 Wedge 09-19-2009, 04:42 PM
jreiter22 Wedge 09-19-2009, 04:47 PM
ben.mid Sorry, only just seen this.... 09-27-2009, 07:36 AM
Otis 3/8 is probably close enough... 09-25-2009, 10:43 AM
jreiter22 Wedge angle 09-25-2009, 01:23 PM
turbine712 so have you seen the fixture... 09-25-2009, 05:43 PM
jreiter22 Washers and pins 09-25-2009, 08:21 PM
Otis Washers for the inside at the... 09-25-2009, 07:39 PM
  1. 09-19-2009, 03:03 PM #1
    jreiter22 is offline
    < Banned User >
    Join Date
    Aug 2009
    Location
    Manhattan Beach CA
    Posts
    185
    Thanked: 25

    Default Wedge angle

    I am making some scales out of wood. One set is teak and is slightly under 1/8 inch thick. When I assembled them there is a 3/8 inch spread at the pivot end. It takes a slight pressure to close to blade width.

    The second set is walnut and slightly over 1/8 inch thick. The walnut scales are much stiffer. I looked at my Bill Ellis disk and he says the wedge should be about the width of the blade and a few degrees.

    Do you have any ideas on what the opening at the pivot should be before installing the blade?
    Last edited by jreiter22; 09-19-2009 at 03:21 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules