I see on some re-scales that folks use a washer that appears to be larger than the #0 brass washer Ive got or aleast the diameter is larger not the size ID but the OD what size are they? i like the way they look
Printable View
I see on some re-scales that folks use a washer that appears to be larger than the #0 brass washer Ive got or aleast the diameter is larger not the size ID but the OD what size are they? i like the way they look
size #00 is what you are looking for
Microfasteners.com has them they are #0W (wide)
Just like my brother G said.
Do not get the #00 ones. They are even smaller than the #0 and will not fit over a 1/16 rod.
you guys rock thanks
I drill the end of a 3/16" rod and cut off washers with a jewelers saw. Then I put a piece of blue painters tape around my index finger and stick it to that. Then I lay down fine sandpaper and sand it to a bright finish. Mack