Results 1 to 6 of 6
Thread: two washers?
LinkBack URL
About LinkBacks-
12-03-2009, 09:56 PM #1Senior Member
- Join Date
- Jul 2009
- Location
- western ma
- Posts
- 164
Thanked: 19
two washers?
I see on some re-scales that folks use a washer that appears to be larger than the #0 brass washer Ive got or aleast the diameter is larger not the size ID but the OD what size are they? i like the way they look
-
12-03-2009, 10:10 PM #2Senior Member
- Join Date
- Dec 2008
- Posts
- 283
Thanked: 181
size #00 is what you are looking for
-
12-03-2009, 10:10 PM #3At this point in time...
- Join Date
- Jun 2007
- Location
- North Idaho Redoubt
- Posts
- 27,029
- Blog Entries
- 1
Thanked: 13245
Microfasteners.com has them they are #0W (wide)
-
12-04-2009, 01:04 AM #4The Shell Whisperer
- Join Date
- May 2008
- Location
- Sin City
- Posts
- 5,597
Thanked: 3384
Just like my brother G said.
Do not get the #00 ones. They are even smaller than the #0 and will not fit over a 1/16 rod.
əˌfisyəˈnädō | pərˈfekSH(ə)nəst | eS'prəSSo | düvəl ləvər
-
12-04-2009, 01:06 AM #5Senior Member
- Join Date
- Jul 2009
- Location
- western ma
- Posts
- 164
Thanked: 19
you guys rock thanks
-
12-05-2009, 02:13 AM #6Mack
- Join Date
- Oct 2009
- Location
- Florida
- Posts
- 632
Thanked: 187
I drill the end of a 3/16" rod and cut off washers with a jewelers saw. Then I put a piece of blue painters tape around my index finger and stick it to that. Then I lay down fine sandpaper and sand it to a bright finish. Mack
-
The Following User Says Thank You to mackie For This Useful Post:
medic484 (12-05-2009)
Reply With Quote