Results 1 to 10 of 11

Thread: washer maker

Threaded View

  1. #1
    Senior Member blabbermouth spazola's Avatar
    Join Date
    Dec 2006
    Location
    Burkburnett TX
    Posts
    3,100
    Thanked: 2392

    Default washer maker

    Here is my new washer maker, it is two pieces of steel held together with roll-pins. I got the idea form Alexander Weygers Complete Modern Blacksmith book. I drilled one hole, put in the roll-pin, then drilled and installed the second roll-pin. After that I drilled the remaining holes for the washer Id's and Od's. I then counter sinked the bottom so the parts would come out easier. The die works with regular punches but I made a punch with a replaceable center to aid in the centering of the washers. I ended up hardening the parts but I am not sure that it was necessary. I ground some clearance on the inside face along the side edges so that I can stick a screw driver in to pry the halves apart.


    If you need washers, have a drill press and are bored, making one might be a good way to stay entertained.


    Charlie
    Attached Images Attached Images    

  2. The Following 4 Users Say Thank You to spazola For This Useful Post:

    ScottGoodman (04-12-2010), shutterbug (04-12-2010), Slartibartfast (04-10-2010), Stubear (04-12-2010)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •