Good point. I'd probably want to fix it. :)
Printable View
Good point. I'd probably want to fix it. :)
Here is one of the first ones, Dan/Floppyshoes and I did it some time back
http://straightrazorpalace.com/works...-gssixgun.html
I've had this problem too.
Experimentation led me to the following solution:
- Apply CA without clouding (okay I know this goes without saying but it's crucial for obvious reasons)
- Let cure at least an hour or two AFTER it is hardened
- level any imperfections and scuff the surface all over. Steel wool is good for this.
- Wipe the surface with a lint-free cloth damp with acetone
- Apply a wash coat of clear shellac (1lb cut will do)
- Lightly scuff, then clean with a damp rag or tack cloth
- You're ready to topcoat with almost anything
This is what I do for crack/dent filling with CA on things like burls where you have knots and holes but want a flat finish.