Thread: anyone know a good yet cheat table buffer/polisher?

I went to Home Depot only to find they sell grinders and not polishers.
Then I took to ebay to find wide varieties of kinds and sizes.
My next question is how important is the horsepower since they vary from .27 to 1.3 hp?
Thanks for any advise in advance.
KC

Harbor freight buffer

get the router speed control
and you have a variable speed buffer
Its 6" but if you mount it on a base it will take 8" wheels too (it might work even with no extra elevation)

This page has plans for a good cheap buffer, down near the bottom of the page.

Charlie

I am trying to navigate through and find the compounds shown in the restore video but can't seem to find it in here. Any tips? Also, how long does one of these buffer wheels last? Should I order a couple extra while I am here along with the compound. They should be carried by them right?
Thanks again.

Introduction To Buffing and Polishing - Caswell Inc.
a lot of info including which compounds to use

+1 on what's already been suggested. I found this thread quite helpful:
http://straightrazorpalace.com/works...fo-thread.html

The workshop sticky has a ton of helpful links, including sites to buy materials:
http://straightrazorpalace.com/works...wers-here.html

Also check out Undream's extensive video tutorial on a complete restore. Several informative videos specifically on using a buffer:
http://straightrazorpalace.com/video...rt-finish.html

I just got the cheap Harbor Freight one. Practiced on it this past weekend with some old door hardware around our house, and tried one razor. The speed takes a bit getting used to and I'm looking at the variable speed controller.

Always remember to wear your safety gear! Goggles and a mask/respirator are a must.

EDIT: as far as wheels, I have two wheels for 80-grit greaseless and then one wheel for the rest of my progression: 120-, 180-, 240-, 400- and 600-grit greaseless, then black and white rouge. Got everything from Caswell online.

Originally Posted by mainaman

Harbor freight buffer

get the router speed control
and you have a variable speed buffer
Its 6" but if you mount it on a base it will take 8" wheels too (it might work even with no extra elevation)

How much will one of thoes speed controls slow the buffer? and is that shorten the life of the motor?