Jimps

Is it possible to put Jimps into an existing blade without annealing it? I have a KB that I like but there are no jimps and I like them for holding on.

A dremel and cutting disc should do the trick, be careful with the tool and be sure to keep the blade cool so as not to screw up the temper. If you dont mind the slow work a small file would also do the trick without the danger.

You can also use diamond files. Check out World's Largest Supplier of Firearm Accessories, Gun Parts and Gunsmithing Tools - BROWNELLS or or Shooting Supplies, Reloading, Gunsmithing, Hunting, Ammunition, Gun Parts & Rifle Scopes — MidwayUSA or any other gunsmithing supplier.

http://straightrazorpalace.com/custo...led-olive.html

Check this thread out.

Charlie

I recall someone, I think it was Joe Chandler, posting that he had seen a guy tape a jigsaw blade to the side of the tang as a guide for the spacing. Following the teeth in the jigsaw blade made for even spacing. I've never tried this myself. :)

Quote:

---

Originally Posted by JimmyHAD

I recall someone, I think it was Joe Chandler, posting that he had seen a guy tape a jigsaw blade to the side of the tang as a guide for the spacing. Following the teeth in the jigsaw blade made for even spacing. I've never tried this myself. :)

---

http://straightrazorpalace.com/forge...ing-guide.html

I guess the results would depend on how hard the tang is and what your cutting tool will be. You could try annealing the tang with a torch with the blade portion in bucket of water. I would try with a beater razor first and get the process down. I learned this process from people that are smarter than me

There are a lot of ways to skin a cat

Charlie

i use gobrec SP? checkering files i got from midwayusa
cutting them in pre HT is iffy but post HT can be doen depending on a few things (clay coat the tang so it does not get full hard or blue temper the tang then cut the softer steel)