Results 1 to 9 of 9
Thread: Loose Pins
Hybrid View
-
07-09-2010, 11:27 PM #1
Loose Pins
Howdy all,
I had a problem that I hope you can help with.
I was shaving today and I notice how my blade was loose in the scales and would swing on me. It would stay fully closed, but if I opened it it would start to swing at certain points.
Does anyone know what causes this? It was tight when I got it but why would it loosen after a few shaves?
Also I hear a few light hammer taps on the pin will fix it up. Does the razor have to be closed or should I open it to those swing spots?Shaving_story on Instagram
-
07-10-2010, 05:22 AM #2
- Join Date
- Sep 2009
- Location
- SE Oklahoma/NE Texas
- Posts
- 7,285
- Blog Entries
- 4
Thanked: 1936Closed. You can use a spoon to tighten the pins. Check the wiki on pinning or tightening pins. Tap the pin only as hard as you can stand the spoon hittingyour fingernail.
Southeastern Oklahoma/Northeastern Texas helper. Please don't hesitate to contact me.
Thank you and God Bless, Scott
-
07-10-2010, 05:24 AM #3
- Join Date
- Sep 2009
- Location
- SE Oklahoma/NE Texas
- Posts
- 7,285
- Blog Entries
- 4
Thanked: 1936Razor should be closed. You can tighten it by the use of a spoon believe it or not. Place the razor on a cutting board and tap the pin. Only tap the pin as hard as you can stand tapping your fingernail. You can find more in the wiki...
Southeastern Oklahoma/Northeastern Texas helper. Please don't hesitate to contact me.
Thank you and God Bless, Scott
-
07-10-2010, 05:40 AM #4
-
07-10-2010, 05:49 AM #5
He's referencing how hard to tap the pin. If you hit too hard your pin could bend and could crack scales and other bad stuff.
-
07-10-2010, 06:21 AM #6
I seem to recall someone once saying that there is a particular side of the pin to tap. There's a difference in the pin head either side of the scales.
So don't do anything just yet and I'm sure someone will explain further.
-
07-13-2010, 04:31 AM #7
- Join Date
- Jul 2006
- Location
- Albuquerque
- Posts
- 133
Thanked: 16Let me share my thinking on the correct side to tap the pin with the caveat that I am very much of a newbie on this topic and might be way offbase. Imagine the razor laying flat on one side with the toe of the blade off center and rubbing against the scale on the bottom side. Assuming the tang is straight, which might not be the case, if you were to push down on the tang near the pin hole, a seesaw effect would imply that the heel would fall and the toe would rise. This logic implies tapping the pin on the top side is correct. Seems to sometimes work for me with the opposite action accentuating, rather than correcting, the problem.