Printable View
It's also important to remember the washers you will need. If you use Butch's way and extend the barrel all the way you will need to find washers to fit the barrel. If you use the tang/flush way you will need to find washers to fit the 2-56 screws. I've even seen it done with the barrel sticking out the pivot just enough to fit a barrel sized washer on each side.
it wouls prob be easier to flush it to the tang and find washers to fit the 2 56 screws from microfasteners.com as I also work with vintage razors only. do you know of a place to find them Max?
I found out that Micro Fasteners - Hobbyists Source - Locknuts - Washers - Machine Screws - Fasteners - Rivets - Wood Screws does have the washers
A #2 washer would fit a 2-56 button head torx screw. The part number is FW02
for steel zinc and FWS02 for stainless steel. for anyone else thats looking. Thanks Again!
Would i use the flat head torx screws in the back the same way with a pivot barrel? Can I get them at the same place?
Was there a link to this stuff that was meant to be posted here? I'd kinda like to know where these particular items can be obtained. This doesn't look like the same stuff I'm seeing on all the sites with the barrel stuff.Quote:
Originally Posted by eTom
Thank you.
Most of the stuff you'll find here:Quote:
Originally Posted by darkwind
KnifeKits.com Designer Knife Kits - Knife Making Supplies - Sheath and Holster Making Supplies
What type of bit would I use to drill the 1/8th hole in the pivot on the razor? Would titanium work on that kind of carbon steel?